DAA - Alpha-Xi Pouch Inlay

This is a complete set of Alpha-Xi Pouch Inlays in the color of your choice. 

These inlays will fit into all the various pockets on the Alpha Xi  pouch body. check the fit first for all pieces before removing the 3M  tape from the back. Most pockets are unique and require their specific  piece. Do not glue an insert in the pocket you  plan to attach the Ball  Joint to.

Please note that these inlays have a protective transparent film on  their front and 3m adhesive tape cover on their back. Both should be  peeled off before installation..

In order to install the inlays do the following:

1. Carefully break the pieces out of their frame. There are several  small bridges holding them in place which can be broken by hand.
2. If you wish, you can use a knife to clean off the tails left by the bridges, but these won’t really be visible once installed.
3. Check you have the correct inlay in hand for the  pocket you are  addressing. Peel off the transparent film from the front, as well as the  3M adhesive cover from the back.
4. Position each inlays into their correct pockets in the pouch body and fit them in place.

Should you wish you remove the inlays after installation, you can do  so using the small holes drilled through the pouch body. In order to  access these holes, you will need to remove all plastic spacers first.  Then, using a sharp tool (like a small hex key) you can push on the  inside of the inlay until it comes loose in the corner. Then, gently  work it out of its pocket. Note that the inlay may break when removed.